-
Change percolation manifold to dual runner full loop design on 2 inch stands. Replace original hard plumbing to flex hose with quick coupler for manifold and stand removal during tank cleaning. (See Optional Modifications to VariTech Plastic Welded Brine Maker)
-
Remove original manifold stands from tank for easier clean out.
-
Move brine holding tank clean out to opposite end of tank from access hole to make the clean outs on the same end.
-
Add vents to overflow tubes to prevent air lock.
-
Add a protective shield over motor to pump drive to prevent injury from contact with rotating shaft.
-
Rewire pump motor from 110 volts to 220 volts to reduce amperage.
-
Add motor control to junction box to accommodate amperage to start motor.
-
Add forklift tubes to frame between tanks to aid in maintenance.
-
Replace frame when it gets rusted out with stainless steel from manufacturer.
